Furuno GP-1850DF - Manual (Page 33)

3-7
3.7 External Equipment Setup (Option)
This section shows you how to set up the GP-1850F/1850DF when external equip-
ment is connected. If a water temperature/speed sensor is installed, you should
complete this section with the boat in the water and running, to confirm speed/
water temperature readout.
Speed Source
1. Press the [MENU] key.
2. Press the software key labeled "DISPLAY OPTIONS".
3. Press the software key labeled "NEXT PAGE" to display the following display.
RETURN
EDIT
DISPLAY
SETUP2
s SPEED SOURCE GPS
TEMP SOURCE OWN XDCR
TEMP GRAPH OFF
ZOOM MARKER OFF
SPEED ADJ. +00%
TEMP ADJ. +00.0
°
F
DEPTH ADJ. +0.0ft
SPD
12.3kt TEMP
62.5
°
F
DEPTH
2000.0ft
DGPS 3D
Figure 3-10 Display Setup 2 Display
4. Select "SPEED SOURCE" by the arrow key.
5. Press the software key "EDIT" to display the following message.
SPEED SOURCE
▲
OWN PDDWHL
GPS
▼
Figure 3-11 Speed Source Display
6. Select source of speed by the arrow key; "OWN PDDWHL" (speed sensor) or
"GPS".
Adjust speed when you select "OWN PDDWHL". Refer to next page.
7. Press the software key labeled "ENTER".
8. Press the [PLOT] key to finish.