FUJITSU C120-E361-04EN - Manual (Page 25)

C120-E361-04EN 1-7
1.3 RCI Setup
7
On main unit A, execute the setrci -c set command to make the settings of the
host node.
Since main unit A is the first unit, host_no is 1.
8
On main unit B, execute the setrci -c set command to make the settings of the
host node.
Since main unit B is the second unit, host_no is 2.
9
On main unit A, execute the setrci -c initconfig command to configure the RCI.
10
Execute the setrci -c addconfigcommand on main unit B to expand the RCI
configuration.
11
Display the RCI status by executing the setrci -c stat command on main unit A.
12
Verify that all the RCI device in the RCI connection are incorporated.
XSCF> setrci -c set 1
The command completed successfully
XSCF> setrci -c set 2
The command completed successfully
XSCF> setrci -c initconfig
The command completed successfully
XSCF> setrci -c addconfig
The command completed successfully
XSCF> setrci -c stat
HOST
address 000101ff
Active
LIST
address pwr alm I/F sys-phase ctgry dev-cls sub-cls tm-out
000101ff OFF - ACT -- host 0001 0b -
000102ff OFF - ACT -- host 0001 0b -
003001ff OFF - ACT -- disk 0400 04 -
003002ff OFF - ACT -- disk 0400 04 -
The command completed successfully