Fluke 434 - Manual (Page 22)

Fluke 433/434
Users Manual
4-4
Menu Navigation
Most of the Analyzer functions are menu operated. Arrow keys are used to navigate
through menus. The Function keys F1 ... F5 and the ENTER key are used to make
selections. Active Function key selections are highlighted with a black background.
How to use the menus is illustrated in the example below on how to adjust the Analyzer
for use with a certain printer type.
SETUP
The SETUP menu pops up.
F4 Submenu SETUP USER PREF appears.
Highlight Printer: .
ENTER
The PRINTER submenu appears. In this menu you can
adjust printer type and baudrate.
Highlight baudrate: .
Adjust the required transmission speed.
Highlight the Printer type you want to use: .
ENTER
Press to confirm the selection.
F5 Press to return to the next higher menu SETUP USER
PREF. This menu is the starting point for many adjustments
such as Display Contrast Adjustment and Reset to Factory
Defaults.
Display Contrast
Use submenu SETUP USER PREF as a starting point. How to get there is explained
above under Menu Navigation:
Adjust the Display Contrast to your personal taste.
Reset to Factory Defaults
Proceed as follows to reset the Analyzer to factory default settings. Bear in mind that
recorded data and adjustments will be lost.
Use submenu SETUP USER PREF as a starting point. How to get there is explained
above under Menu Navigation:
F1 Press to start the reset to default settings. Because of the risk
of unwanted erasure of data, a confirm menu pops up.
F5 Press to confirm the reset.