Low power mode setting, Select interface – FUJITSU fi-4750C User Manual
Page 80
7-11
13. Low Power Mode Setting
1 Press “Next”
or “Previous”
and let the
scanner display Screen 53.
2 At Screen 53, press
or
to select the
time duration. A minimum of 5 min to the
maximum of 60 minutes can be selected.
Then press
to activate the setting.
NOTICE
The default time recommended by the E
NERGY
S
TAR
®
program is 15 minutes. The default for the fi-4750C
scanner is 15 minutes, as recommended.
3 Press
to return.
14. Select Interface
1 Press “Next”
or “Previous”
and let the
scanner display Screen 54.
NOTICE
The screen 54 will appear oniy when the scanner has proper interface boards or option boards in the third
party slot.
2 At Screen 54, press
or
to select the
interface type. Press
if you want to
change the setting.
NOTICES
1. Normally, this setting does not have to be changed.
2. When an appropriate board is installed in the third party slot of the scanner, the scanner automatically
turns off the SCSI interface, activating the board in the third party slot. Screen 54 can be used to
forcibly change the selected interface. The selected interface is then forcibly changed.
3. The SCSI interface and the board installed in the third party slot cannot be used at the same time.
4. The default is Auto.
3 Press
to return.