FUJITSU fi-4750C - Manual (Page 37)

3-3
Manual Feed Mode Setting
In this mode, the scanner waits for some predetermined time before issuing a “Paper Empty” message
after all documents are read. This predetermined time (time-out limit) is specified in the Setup mode.
Therefore, you can set the next documents on the ADF chute without interrupting the reading operation.
The procedures for setting the manual feed mode are as follows:
1 Turn the power On and verify that “Scanner
Ready” is displayed on the LCD.
2 Press then the scanner displays
Screen M2.
3 Press then the scanner displays
Screen M3.
4 Press then the scanner displays
Screen M4.
5 Select “Yes” by pressing . Then press
.
6 Press to return to the “Scanner Ready”
screen. Note that “Manual Feed” is shown on
the LCD. This means that the scanner is in
Manual Feed mode.