FUJITSU SCANSNAP NETWORK SCANNER N1800 - Manual (Page 15)

15
Chapter 4 Checking the Network Connection
This section describes how to check the status of the
network connection.
The network connection can be checked by performing a
ping test.
1.
Log in to the scanner with the user name and
password of the administrator.
Enter "admin" for [User Name] and the password
specified in the basic settings for [Password]. The
default password is "password".
DThe [Select Mode] window appears.
2.
Select the mode and function, and press the
[OK] button.
DThe [Admin Menu] window appears.
3.
Select [Network Settings] J [Basic] J [Ping].
DThe [Ping] window appears.
4.
Check the status of the network connection.
For [Address], enter the IP address, host name, or
FQDN of the computer to be checked.
5.
Press the [Ping] button.
DA ping test is performed and the results are
displayed.
If the result shows "Lost=0 (0% loss)", the network
connection is functioning normally.
For any other result, refer to "Checking Basic
Network Operation with a Ping Test" (page 17).
6.
Press .
DThe [Admin Menu] window appears.
7.
Press the [Logout] button to log out of the
scanner.
If you specify settings on the [Select Mode] window,
the [Admin Menu] window appears from the next login.