Hitachi US7070447-001 - Manual (Page 32)

HiSpeed Switch Troubleshooting Guide
4-4 US7070447-001, Rev 01
Draft Level—Hitachi Confidential
Console Port
The console port has a DB-9 male connector used to connect a management
terminal to the switch by means of a straight-through DB-9 to DB-9 standard
serial port cable. Using a terminal, you can monitor the results of startup
self-diagnostics, perform manual boot configuration and SNMP agent
configuration, and customize your network using the supplied menus and screens.
The pin assignments for the console port are provided in Table 4-2.
The console port provides VT100 terminal emulation with the following
parameter settings:
❒ Baud Rate: 9600
❒ Data bits: 8
❒ Stop bit: 1
❒ Parity: None
❒ Flow Control: None
Use the CLI commands
CONSOLE/SHOW
CONSOLE/CONFIG
Table 4-2. Console Port Pin Assignments
Pins Signal Name
1 Not Used
2 Transmit data (TD) to terminal
3 Receive data (RD) from terminal
4 Not used
5 Common signal ground
6 Not used
7 Not used
8 Not used
9 Not used