Vivotek SD9161-H-v2 2MP PTZ Network Dome Camera User Manual
Page 29
VIVOTEK
29 - User's Manual
General Connection
When using a non-PoE switch
Use a High Power PoE power injector (separately purchased) capable of 60W output or higher
to connect between the Network Camera and a non-PoE switch. Sufficient power is required for
low temperature conditions when the onboard heater is activated.
Connect the power wires to a DC 24V power adaptor (user-supplied). The DC 24V adapter
can drive the camera and the onboard heater.
You can connect both power sources for redundancy in power supply.
Power over Ethernet (High Power PoE)
Internet connection with static IP
Choose this connection type if you are required to use a static IP for the Network Camera.
Please refer to LAN on page 96 for details.
Internet connection via PPPoE (Point-to-Point over Ethernet)
Choose this connection type if you are connected to the Internet via a DSL Line. Please refer to
AC 24V 3.5A
Adapter (Separately
purchasedied)
PoE Switch (15W output)
and / or
Non-PoE Switch
PoE Power Injector