MOTU 828x 28x30 Audio Interface with ThunderTechnology User Manual
828x, User guide for windows
Table of contents
Document Outline
- Part 1 Getting Started
- Quick Reference: 828x Front Panel
- Quick Reference: 828x Rear Panel
- Quick Reference: MOTU Audio Console
- 1 About the 828x
- 2 Packing List and System Requirements
- 3 Installing the 828x Software
- 4 Installing the 828x Hardware
- Part 2 Using the 828x
- 5 MOTU Audio Console
- 6 Front Panel Operation
- 7 Configuring Host Audio Software
- 8 Reducing Monitoring Latency
- 9 CueMix FX
- Overview
- A 16-bus mixer with EQ, compression and reverb
- Advantages over host-based mixing and processing
- Opening CueMix FX
- CueMix FX basic operation
- The Mixes tab
- The Inputs tab
- The Outputs tab
- The Channel Settings section
- The Channel tab
- The EQ tab
- Vintage EQ
- Enabling EQ
- Vintage EQ Quick reference
- How the vintage EQ works
- EQ filters
- EQ filter styles
- Low pass and high pass filters
- The Dynamics tab
- Enabling Dynamics
- Compressor
- Leveler
- The Meters tab
- The Reverb tab
- Enabling reverb
- Routing inputs, busses and outputs to the reverb processor
- Reverb sends
- Reverb returns
- Split point
- Primary controls
- Early reflections
- Reverb design
- The Monitor Group
- DSP meter
- Solo light
- Talkback and listenback
- Shortcuts
- File menu
- Edit menu
- Devices menu
- FFT and Spectrogram display
- Oscilloscope
- X-Y Plot
- Phase Analysis
- Tuner
- Configurations menu
- Talkback menu
- Phones menu
- Control Surfaces menu
- 10 MOTU SMPTE Console
- Part 3 Appendices
- A Troubleshooting
- B Audio I/O reference
- Index