Kramer 4x4 Audio and Dante Mixer - Manual (Page 30)

Kramer Electronics Ltd.
FC-404NETxl – Using Embedded Webpages 28
Defining Communication Settings
Network settings include the Ethernet settings (Network) and the Dante settings.
Set the FC-404NETxl communication parameters, for the Network and Dante, including
DHCP, the IP Address, Mask, gateway and so on using the Network tab in the Device
Settings page.
FC-404NETxl enables performing the following functions:
•
Changing Network Settings on page 28 .
•
Setting DHCP to Off on page 29 .
Changing Network Settings
To change the Network settings:
1. In the Navigation pane, click Device Settings . The General tab in the Device Settings
page appears.
2. Select the Network tab:
Figure 36: Settings Page – Network Tab
3. If DHCP is set to Off, change any of the parameters (IP Address, Mask and/or Gateway).
By Default, Network DHCP is set to On and Dante DHCP is set to Off.