Panasonic AV-HS6000 2 M/E Live Switcher Main Frame & Control Panel (Dual Redundant Power Supplies) - Manual (Page 58)

– 58 –
Chapter 5 Basic Operations — Wipe
f Modify the following pattern waveforms.
- 3D: 99, 100, 101, 102
1
Select the / button → [BKGD] → [Modify] tab.
2
Select an item in [Light] in the [Pageturn] column.
[Off] Does not add the lighting effect.
[On] Adds the lighting effect.
3
Set [Size] in the [Pageturn] column.
f Set the size for reduction.
4
Set [Radius] in the [Pageturn] column.
f Set the radius for the turn page effect.
5
Set [Angle] in the [Pageturn] column.
f Set the direction for the turn page effect.
Setting spin effects
A spin effect can be added during the background transition.
1
Select the / button → [BKGD] → [Modify] tab.
2
Set [X‑Spin], [Y‑Spin], and [Z‑Spin] in the [Spin] column.
f This sets the amount of rotation of the spin effect during background transition.
f An effect can be added to the following pattern waveforms.
- [Z-Spin]
WIPE: 1 - 15, 17
SQ: 42 - 45
- [X-Spin], [Y-Spin], [Z-Spin]
SQ: 41, 51 - 54
f The pattern waveform SQ46 (spin waveform) with the system version earlier than 3.00-00-0.00 is integrated to SQ41 with the system version
3.00‑00‑0.00 or later. It is converted to the pattern waveform WIPE1 when a project file set in SQ46 with the system earlier than 3.00‑00‑0.00 is
loaded.
3
Select the [Spin Mode] item in the [Spin] column.
[Off] Does not spin regardless of setting value of [X-Spin], [Y-Spin], and [Z-Spin].
[Trans Spin] Spins in specified amount of spin depending on the transition.
[Auto Spin]* Spins in speed in accordance with specified amount of spin regardless of the transition.
[Manual Spin]* Tilts in specified amount of spin regardless of the transition.
* It may become discontinuous at the edge of transition in the [Auto Spin] or [Manual Spin] modes.
Setting the Multi Pattern effect
The wipe pattern can be divided to the specified number.
f Enabled when the following pattern waveform is selected.
- WIPE
1
Select the / button → [BKGD] → [Modify] tab.
2
Set the specification method of the number of division in [H/V Sync] of the [Multi] column.
[On] Makes the number of division the same in horizontal and vertical directions.
[Off] Different number of division can be specified for horizontal and vertical directions.
3
Set the number of division in horizontal and vertical direction in [H] and [V] of the [Multi] column.
Setting the Modulation effect
An effect to ripple the wipe edge can be added.
f Enabled when the following pattern waveforms are selected.
- WIPE: Except 24 (Free Wipe)
- SQ: 42, 43, 44, 45
1
Select the / button → [BKGD] → [Modify] tab.
2
Set [Amplitude], [Frequency], and [Speed] in [H Modulation] and [V Modulation].
[Amplitude] Sets the amplitude of the wave.
[Frequency] Sets the frequency of the wave.
[Speed] Sets the speed of the wave movement.