Panasonic AV-HS6000 2 M/E Live Switcher Main Frame & Control Panel (Dual Redundant Power Supplies) - Manual (Page 147)

– 147 –
Chapter 8 System Menu — System settings
Setting the image and the WFM/VECT to display on the Menu Panel AV‑HS60C3
Set the image and the WFM/VECT to display on the Menu Panel AV-HS60C3.
Setting the image to encode
1
Select the button → [SYSTEM] → [Display] tab.
2
Select an item in [Target] in the [Video Codec] column.
f Select the image to encode in the Main Frame AV-HS60U1/AV-HS60U2.
[DISP]
Encodes the image selected in the DISP bus, and displays the image, WFM and VECT on the Menu Panel AV-HS60C3
connected to the main control panel.
[External]
Displays the image on the external device connected to the terminal of the Main Frame AV-HS60U1/AV-HS60U2.
When this setting is applied, the image selected in the DISP bus, WFM, and VECT is not displayed in the Menu Panel
AV-HS60C3.
Setting the WFM (waveform monitor)
1
Select the button → [SYSTEM] → [Display] tab.
2
Select an item in [Style] in the [WFM] column.
f Select the display method of the signal waveform.
[Parade] The signal waveforms are displayed side-by-side.
[Overlay] The signal waveforms are displayed on top of each other.
3
Select an item in [Mode] in the [WFM] column.
f Select the signal with the waveform displayed.
[YPbPr] Y, P
B
, and P
R
signals are displayed.
[RGB] R, G, and B signals are displayed.
[Y] Only the Y signal is displayed.
Setting the VECTOR (vectorscope)
The reference marker of the color bar can be selected.
1
Select the button → [SYSTEM] → [Display] tab.
2
Select an item in [Bar Target] in the [Vector] column.
[75%] The reference marker of the 75% color bar is displayed.
[100%] The reference marker of the 100% color bar is displayed.