iSys iTerra Elite II Color LED Plotter User Manual
Page 42
June 2011: Revision 002
42
STEP 3
STEP 4
Holding the new fuser by its handle, make sure that it is
the correct way round. The retaining levers (b) should be
fully upright, and the two locating lugs (c) should be
towards you.
Lower the fuser into the printer, locating the two lugs in the
slots in the metal partition which separates the fuser from
the image drums .Push the two retaining levers (b) towards
the rear of the printer to lock the fuser in place.
STEP 5
Place the drums back into the printer and replace the
lid.