iSys iTerra Elite II Color LED Plotter - Manual (Page 29)

June 2011: Revision 002
29
Error What Happened
Status: Error 00 Emergency stop (guide door opened during motor
movement)
Status: Error 01 Switch panel communication error
Status: Error 02 Internal error
Status: Error 03 Internal error
Status: Error 10 Media not found over lower load sensor after load
Status: Error 11 Media not positioned between load sensors
properly after load advance
Status: Error 31 Cutter did not leave home position in required time
Status: Error 32 Cutter did not finish cut in required time or can't
home it
Clearing Paper Jams
STEP 1 STEP 2
Press the cover release and open the top cover. Note the position of the four toners cartridges (a) and image
drums (b). It is essential that they go back in the same
order.
WARNING: If the printer has been powered on, the fuser will
be hot. This area is clearly labeled. Do not touch.