European directives compliance, Lvd/emc directive, Weee directive–2002/96/ec – H3C Technologies H3C S9500E Series Switches User Manual
Page 99: Usa regulatory compliance, Fcc part 15

89
European Directives Compliance
LVD/EMC Directive
H3C S9500E Series Routing Switches comply with the European Low Voltage Directive 2006/95/EC
and EMC Directive 2004/108/EC.
WEEE Directive–2002/96/EC
The products this manual refers to are covered by the Waste Electrical & Electronic Equipment (WEEE)
Directive and must be disposed of in a responsible manner.
USA Regulatory Compliance
FCC Part 15
H3C S9500E Series Routing Switches complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
•
This device may not cause harmful interference.
•
This device must accept any interference received, including interference that may cause undesired
operation.
If the customer modifies the equipment without the authorization of H3C, which directly or indirectly
contribute to the equipment incompliance with FCC requirements for Class A digital devices, H3C is not
liable for such interference problem and the expenses incurred therefrom shall be covered by the
customers.
Note
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
FDA
H3C S9500E Series Routing Switches Conform to the applicable requirements of 21 CFR Subchapter J