Displaying the power supply system of your switch – H3C Technologies H3C S9500E Series Switches User Manual
Page 68
58
Displaying the power supply system of your switch
Use the display power-supply command to display the power supply system of your switch.
•
In standalone mode:
PSU 1 state: Normal
PSU 2 state: Fault
Line-card power status:
Slot Board-Type Watts Status
---- --------------- ----- ------
2 None -- Absent
3 None -- Absent
4 None -- Absent
5 None -- Absent
6 None -- Absent
•
In IRF mode:
Power info on chassis 1:
PSU 1 state: Normal
PSU 2 state: Absent
Line-card power status:
Slot Board-Type Watts Status
---- --------------- ----- ------
2 LSR1GT24LEC1 85 On
3 LSR1GP48LEC1 115 On
4 None -- Absent
5 Unknown 200 Wait
6 LSR1GT24LEC1 85 On
Table 16 Command output
Field Description
PSU x state:
State of power supply x.
Line-card power status:
Power status of each line card.
Status
Power supply status of the card:
•
on—The card is normally supplied with power.
•
absent—The card is not in the slot.
•
wait—The card is to be supplied with power.
•
off—The card is unsolicitedly powered off due to user
operation or over-temperature protection.
Power info on chassis 1
Information about the power supply on the member switch 1.