beautypg.com

Installing a sub power supply, Installing a card – H3C Technologies H3C S9500E Series Switches User Manual

Page 46

background image

36

Figure 31 Installing an NEPS3500-A power frame

IMPORTANT:

For a switch that requires power supply redundancy, install the same number of sub power supplies in the
two power frames.

Installing a sub power supply

1.

Pull the handle of a sub power supply downward to the unlock position.

2.

Gently push the sub power supply into the AC power frame (NEPS3500-A) until the rear side of the
sub power supply makes close contact with the power frame backplane.

3.

Push the handle upward so that the handle locks the sub power supply in place.

Figure 32 Installing a sub power supply

Installing a card

You can install MPUs and LPUs in a similar way. This section describes how to install an MPU.

See also other documents in the category H3C Technologies Routers: