Cleaning debris from the cutting zone – Formax ColorMaxLP Operator Manual User Manual
Page 53

ColorMaxLP Label Printer
Printer Maintenance
53
Cleaning Debris from the Cutting Zone
Clear all debris from the cutting zone to avoid contaminating the print zone, especially
fine dust particles.
1. Turn off power to the printer. See
Printing Borderless
(Full-Bleed) Labels
on page 32.
2. Open the top cover.
3. Vacuum any debris from the cutting zone (shown
below in green).
4.
Open the clamshell
and also check below the cutting zone, at the bottom of the
printer and in front of the ink cartridges.
5.
Close the clamshell
and top cover.
6. Open the front cover and remove any cutting debris.
cutter path