Formax ColorMaxLP Operator Manual - Manual (Page 19)

Setting Up the Printer
19
NETWORK
2. MANUAL
To connect printer to network
h
i
j
a
Printer Network
Network
Connect printer to network using Ethernet
b
c Set DHCP Settings to Manual
NETWORK
2. DHCP SETTINGS
Press until display reads
Network , then press Select
Press until display reads
DHCP Settings , then press
Select .
CONFIGURATION
8. NETWORK
Press until display reads Manual ,
then press Select . Press Return to go
back to the Network menu
d Set the Static IP Address
STATIC IP
0 0 0.
0 0 0.0 0 0.0 0 0
Enter the first Static IP digit using
the
+ or - button, then press
Select . Repeat for next eleven
digits. Press Return once when
complete
NETWORK
3. IP SETTINGS
Press until display reads IP
Settings , then press Select three
times
e Press until display reads Subnet Mask ,
then press Select two times.
Enter the Subnet Mask using the same
steps as when setting the Static IP address
f Press until display reads Default
Gateway , then press Select two times.
Enter the Default Gateway using the same
steps as when setting the Static IP address
g
Press until display reads Wins Server ,
then press Select two times.
Enter the Wins Server using the same steps
as when setting the Static IP address
Select Install Driver from the Installation window
Insert Installation disc into computer
Select Configure to print over the Network
and click Next
If you will be using DHCP to set the IP
Address, skip to step
h .
To assign the printer a Static IP address, the
Security Level must be set to 2. Please see
Selecting the Security Level on page 12.