Troubleshooting printer setup – Formax ColorMaxLP Operator Manual User Manual
Page 20

20
Setting Up the Printer
Formax
I
Forward to eject
I
Troubleshooting Printer Setup
If Mech Error 2 or Mech Error 3 appears on the control panel during installation, check
the following.
Possible Cause
Solution
Service station is jammed.
Ensure that the cardboard is removed from inside the
printer.
Service station was tilted
during shipment.
1. Manually
open the clamshell
to its highest position.
2. On the control panel, select
(Config)
>
Service
Station
>
Eject. Wait for the printer to eject the service
station.
3. Turn off the printer, beginning with the power
button on the control panel. When the display turns
off, turn off the power switch on the back of the
printer.
4. Verify that the Service Station is free and can be
manually pulled forward to the front bracket. If yes,
proceed to Step 5. If not, contact Technical Support.
5. Align the service station with the guide rails and
slide it back into the printer.
6. Check the alignment: the cap on the service station
must be parallel to the edge of the platen.
7. Continue pushing the service station while you
manually rotate the positioning gear backwards to
move the station all the way into the print engine.
8. Close the clamshell.
9. Turn on the printer.
Positioning Gear
Platen
Cap
I
Backward to install
I