American Time SiteSync IQ - Manual (Page 33)

33
© American Time
SiteSync IQ Installation Manual
Wired Signal Circuit Option
Glossary
Appendix
Troubleshooting
Clock
Installation
System Contr
oller
Installation
Intr
oduction
Programming Signal Circuits (Keypad Interface)
Optional signal relays for controlling signal or lighting circuits must be assigned to schedules of events for automatic control. Multiple
circuits can be assigned to one schedule, but each signal circuit can be assigned to only one schedule.
Each signal circuit is also programmed with a default event duration. This allows different signal circuits assigned to the same schedule to
be activated for different lengths of time for the same event. For example, a school may have circuit 1 connected to the elementary bells
and wish to ring those for 3 seconds. It may have circuit 2 connected to the middle school bells and wish to ring those for 5 seconds.
The same events can be assigned to a single schedule but will have different durations on different circuits when using circuit duration
defaults. This default duration can be overridden by the duration specified for an event (described in the Programming Events section).
n Note: System Controllers with the Ethernet option can also be programmed via the Remote Connect web interface (see page 33).
u Setting Signal Circuit Schedule and Duration
a. Press P3 . Enter User Lock (unless User Lock is disabled) and
Press O (unless User Lock is disabled) to enter Circuit Menu.
b. Press 1 to select the Signal Circuit Schedule Assignment screen.
The current schedule assignments for all circuits are shown. To
change the schedule assignment for a circuit, press the number of the
circuit (i.e. 1 ).
c. Assign a schedule to this circuit by pressing the > or < buttons
until the correct schedule is displayed. (Pressing 0 disables the circuit)
Press O to accept.
This returns you to the Signal Circuit Schedule Assignment screen ( b).
Press B .
Press 2 to bring up the Duration screen.
Circuit Menu
Cir:01 Choose Sch
Sch: 01 00=Special
OK=Accept
Circuit Menu
Select Circuit:
Cir 1 2 3 4 5 6
Sch 01 01 02 02 03 03
Circuit Menu
View Circuits for:
1=Schedule 3=On/Off
2=Duration Prog=Exit
1c
1b
1a
Signal Circuit Menu
From Program
Menu
User Lock
Enable
Circuits
Select
Circuit
Select
Duration
1-9, < or >
Select
Schedule
Select
Circuit
Exit to Main
Screen
View Circuits
1=Schedule 3=On/Off
2=Duration
3
3
2 1-6
1-6 1
OK
PROG
OK
OK
OK
n Note: To return to the View
Circuits screen from any of these
screens, press the
B button.
MON MAR 10 2014
10:38:06 AM USCT
American Time
Status=AUTO ETH=Y