American Time SiteSync IQ - Manual (Page 22)

© American Time
22
SiteSync IQ Installation Manual
Wireless Sync Option
MON MAR 10 2014
10:38:06 AM USCT
American Time
Status=AUTO CDMA=S
abcdefghijklmn
For installations with existing wired signal devices in locations remote to the SiteSync IQ System Controller. This involves a
second, wired IQ System Controller in an area remote to the wireless IQ System Controller.
n Note: Requires reception from wireless transmitting SiteSync IQ System Controller.
Example application: The wireless transmitting system controller (A) is on top of the building for best signal coverage, and the wired devices
(clocks, bells, etc.) terminate on a lower floor (B) or area not near the transmitting unit.
Programming Procedure
A: Transmitting SiteSync
IQ System Controller
B: Receiving SiteSync
IQ System Controller
Glossary
Appendix
Tr
oubleshooting
Clock
Installation
System Contr
oller
Installation
Intr
oduction
Set Menu Mode
Enter User Lock:
xxxx
PROG=EXIT OK=ENTER
Set Menu Mode
Time Sync Option is
Available: WLS
8=Sync now OK=Set
To sync Receiving System Controller with correct time & date:
u
Confirm Transmitting SiteSync IQ system controller (A) is powered and
transmitting.
n Note: After the system controller (A) has been operating for 24 hours, it will
enter Quiet Mode. Pressing 3-5-7 on the keypad will disable Quiet Mode for 6
hours. Reference Appendix J for more details on Quiet Mode.
v
Press: P1 , to Set Menu Mode.
w
Enter User Lock and press O .
x
Press: 9 , to sync the receiving (B) System Controller.
y
Press > until WLS option is chosen.
z
Press 8 to sync time.
n Note: If "WLS Sync Successful" is displayed, press OBB to return to
Main Screen.
If "WLS Sync Failed" is displayed, reference the troubleshooting guide.

The Wireless sync option is now configured and will update the time on the
System Controller automatically once each hour at a time preset at the
factory.
n Note: When Wireless synchronization is working, WLS=S will be displayed on
the screen in small text mode as shown in screen shot
7
. If a synchronization
attempt fails, WLS=N will be displayed.
3
4, 5 and 6
Turn on the power to the System Controller
MON MAR 10 2014
10:30:06 AM USCT
American Time
Circts=Auto WLS=S
7
Wireless Receiver