American Time AllSync Plus - Manual (Page 26)

© American Time
26
AllSync Plus Clock Installation
& Operation Manual
Glossary
Appendix B LED
Illumination
Appendix A
Specifications
Tr
oubleshooting
General Operation
Installation
Intr
oduction
AllSync Plus Clock Specifications
Page 1 of 2
140 3rd St. S, PO Box 707, Dassel, MN 55325
800-328-8996 • american-time.com PS03047 Rev G
AllSync Plus ®
Dual Motor
Molded Case
FEATURES
• 5 Year Warranty
• UL/cUL Listed - 12" surface mount only
• Microprocessor controlled movement
• 15 minutes of backup power (no batteries required)
• Accuracy to within ±1 second of a master clock
• Reduced power consumption
• Attractive modern design
• Impact-resistant black plastic case
• Shatter-resistant safety crystal
• Diagnostic LED
DESCRIPTION
The american time ™ AllSync Plus clocks are provided in round only high impact black plastic cases with clear
polycarbonate crystals and bold, black numerals and minute markers on a non-yellowing white dial. Stylish hour and minute
hands are aluminum with a black finish and a red sweep hand. Other bezel colors available. Consult factory.
The american time ™ AllSync Plus clock is designed to work with multiple master clocks and correction signals. This unit is
programmed to identify the signal it receives from the master and operate as that style of clock. Changing clock operation
from one style to another is as easy as unplugging the clock from one system and plugging it into another. If needed,
changing the placement of 2 small jumpers on the circuit board can change the voltage required to run this clock from
120vac to 24vac or 24vac to 120vac. This clock provides 15 minutes of backup run power without the use of batteries. If a
power outage should last longer than 15 minutes, the clock will synchronize to the master clock at the hourly and 12 hour
correction cycles.
Correction Signals
Works on:
• Hourly Correction: 28.75-35 seconds starting at the 59th minute and 30th second. 12 hour correction: 13 minutes and 52
seconds-18 minutes and 8 seconds starting at 5:12:00 (am and pm). Note: This protocol switches off the run line during
the hourly correction.
ORDERING INFORMATION
Part # Description Part # Description
U44BAGA904 10" Rd Surface 120vac U44BAHA904 10" Rd Surface 24vac
U45BAGA?04 10" Rd Flush 120vac U45BAHA?04 10" Rd Flush 24vac
U54BAGA304 12" Rd Surface 120vac U54BAHA304 12" Rd Surface 24vac
U55BAGA?04 12" Rd Flush 120vac U55BAHA?04 12" Rd Flush 24vac
U53BAGA204 12" Rd Double dial wall 120vac U53BAHA204 12" Rd Double dial wall 24vac
U52BAGA204 12" Rd Double dial ceiling 120vac U52BAHA204 12" Rd Double dial ceiling 24vac
Note:
Double dial mounting requires a 4" square electrical box in the wall or ceiling.
Surface clocks have a molded in hanger in the plastic cases.
12" surface clocks come complete with security bracket
Replace the ? in the part number with the number from the list below that will correspond with the system you’re replacing.
New flush mount installations require backboxes.
0 = Faraday
1 = National 5 = Simplex ® 6 = Cincinnati/Edwards
7 = 2-hook 8 = Setco 9 = R&H (keyhole)
®