Microtel Series 500 - Manual (Page 22)

15
An overview of the “navigation” through the many screens which are accessed to
configure and program the many features of the dialer may be found in the appendix
chart entitled, System Screen Navigation Diagram. To configure the type and location
of I/O cards in the system, access the System status Screen by pressing HALT. Press
the SEQUENCE key to access the Dialer Test and Setup Screen. Then use the
PREVIOUS and NEXT keys to access the Select I/O screen as shown below.
Using the PREVIOUS and NEXT keys, move the highlighted cursor to each card slot
position and use the SELECT key to toggle the entry to the physical card type which
occupies that card slot. Card slots are numbered from 1 to 5, beginning from the left
side of the lower card cage. After selecting the proper card type for any card position,
highlight and SELECT the INITIALIZE field to setup the system’s memory for that type
of card. When the inventory of I/O Option Cards is correct, move the highlighted cursor
to the EXIT field and press the SELECT key.
)
IMPORTANT - CIRCUIT CARD ORIENTATION - IMPORTANT
All circuit cards in the system should be oriented so that that the components are facing
towards the LEFT side of the system. Reversal of the cards may cause damage to the
system.