Interlogix UltraView IP PTZ 36X Camera User Manual - Manual (Page 63)

Chapter 7: Alarm setup
UltraView IP PTZ 36X Camera User Manual 59
E-mail link Check to send an e-mail when an alarm is detected.
Trigger recording Check the input option shown to select the video channel from
which to start recording.
Trigger alarm output Check which of the camera’s alarm outputs is triggered: Alarm
Output 1 or Alarm Output 2. More than one output can be selected.
6. Click Save to save changes.
Event schedule for alarms
Use the deployment time menu to schedule when events can be registered. It
specifies when the alarm inputs and outputs as well as motion detection and
tamper alarms (called “Shelter alarms” here) are operational. Outside of these
scheduled periods the system cannot register events. You can configure up to
four event periods a day.
For the event schedule to be operational, you must also define the motion
detection parameters (see “Motion detection” on page 57) as well as the alarm
input and output parameters (see “Alarm set up” on page 60).
Figure 26: Deployment time screen