Interlogix UltraView IP PTZ 36X Camera User Manual - Manual (Page 45)

Chapter 5: Motion setup
UltraView IP PTZ 36X Camera User Manual 41
Parameter Description
Call Calls up the selected preset. The camera moves to this preset
position.
Note: Predefined presets can be called up but cannot be
changed.
To set a preset position:
1. In the Motion folder, click the Preset subfolder to open its screen.
2. Use the on-screen PTZ buttons to move the camera to the desired position.
3. Click Save to save this preset position.
Note: There may be restrictions to the preset position if motion limit settings
have been enabled. See “Limit PTZ movement” below for further information.
To call up a defined preset position:
1. In the Motion folder, click the Preset subfolder to open its screen.
2. Select the desired preset from the drop-down list.
3. Click Call or . The camera lens moves to this selected preset.
Limit PTZ movement
You can limit the movement range of the PTZ camera in order to restrict the area
under surveillance. This can useful be when you do not want an area in the field
of view to be observed such as a neighboring property, for example. The focus
can also be restricted so that the camera can’t focus in too closely on an object.