Interlogix UltraView IP PTZ 36X Camera User Manual - Manual (Page 13)

Chapter 2: Installation
UltraView IP PTZ 36X Camera User Manual 9
5. Make sure the housing tab is closed and then PUSH the housing into the
pass-through hole (A).
Hold the housing and fix it by screwing the housing tabs down to the
mounting surface (B).
A. B.
6. Insert the PTZ module into the housing.
Align the PTZ module with the housing by aligning the arrows. Push the PTZ
module into the housing, a ‘ke~ ke~’ sound will indicate when PTZ module is
correctly installed. If not, please remove and reinstall it.
Note: If using a SDHC card with the camera, insert it into the camera before
inserting the PTZ module into the housing.
7. Re-attach the bubble by screwing it to the housing using three M3 screws.
8. Install the trim ring.
Align the trim ring to the housing, and insert the fix-pins to the holes. Then
rotate the ring clockwise.