Interlogix TVE Series - Manual (Page 19)

TVE-400/800-1600 H.264 IP Video Encoder User Manual 15
Save playback file to: Set the saving path for the clipped video files in
playback mode.
3. Click Save to save the settings.
Time settings
You can set up the date and time that will appear on-screen and time stamped
recordings. The start and end time of daylight savings time (DST) in the year can
also be set.
A Network Time Protocol (NTP) server can also be set up on your encoder to
keep the date and time current and accurate. If the encoder is connected to a
Dynamic Host Configuration Protocol (DHCP) network that has time server
properties configured, the cameras will synchronize automatically with the time
server.
To configure time settings:
1. Click Device Configuration > Device Parameters > Time Settings. The
Time Settings window appears.
2. Select the time zone.
Select the time zone that is closest to the device’s location from the drop-
down list.
3. Configure the time synchronization method: NTP server or manually.
Configuring time sync by NTP server: Check the NTP box. Enter the IP
address and port of the NTP server.
Note: If the encoder is connected to a public network, you should use a NTP
server that has a time synchronization function, such as the server at the
National Time Center (IP Address: 210.72.145.44) or europe.ntp.pool.org. If
the encoder is set up in a more customized network, NTP software can be
used to establish a NTP server used for time synchronization.