Panasonic SC-AK15 - Manual (Page 29)

To switch the timer OFF
Press ©PLAY/0REC and check "©REG” goes out.
if you set the timer wrongly
Press ©PLAY/0REC so that “©REG" goes out. Then, repeat the
procedure from step H .
To check settings
Press GLOCK/TiMER to select ‘©REG’’.
Two seconds later, the display will change in the loilowing order.
Recording start time
@ Recording over time
® Recording source
You can check settings even when the system is OFF.
To enjoy the desired source after the timer setting is completed
The music source is stored in the timer memory and the timer wili
start in this preset condition. However, the reverse mode and tape
direction do not get stored in the timer memory.
1. After step M , turn on the power and start playing the desired
source.
w>
C
•I
4)
4)
S
2, (After playing the desired source)
Confirm that a tape is inserted into Deck 2.
Reset the reverse mode and tape direction if you have changed
any of them.
Press POWER to put the unit on standby.
Turning the timer ON/OFF
As long as "©REG" is displayed, the record timer will come ON
everyday as set.
You can turn the timer ON/OFF by pressing ©PLAY/OREC while
power is OFF.
Remember that when ©REC” is displayed, the timer is ON. When
not displayed, the timer is OFF. •
• If the power is ON, the timer will not function. The system must be
in the standby mode.
• If you switch the power to the standby mode while the record timer
is functioning, the OFF time setting will not be activated.
• If AUX is selected as the source, when the timer comes ON, the
system will turn ON, will engage “AUX" as the source and will start
recording. If you want to record from the connected component,
set the component's timer to the same time. (See the instruction
manual that came with the component.)