Marking an unmarked tape, Insert the pre-recorded tape with record tab, Push – Panasonic PV-7664 User Manual
Page 25: Push play to start commercial marking
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Multi Function Dispiay
Marking an Unmarked Tape
This feature allows you to turn your existing unmarked tapes into
Commercial Advance tapes. The VCR will scan the previously
recorded tape for commercial segments, and then mark it.
Insert the pre-recorded tape
with record tab.
Recorded segments must be at least 15 minutes
=
in length or marking cannot be performed.
If necessary, push REW or FF to place the tape at the start point of
a recorded segment of over 15 minutes for commercial marking.
■ Push MENU to display
the menu screen.
Push AT to select
“SET UP VCR,” and then
push ► to display the
“SET UP VCR” screen.
-------------------MENU................... ........
кНяД11АЧ*!:1
SET CLOCK
SET UP CHANNEL
IDIОМА/LANGUE:ENGLISH
SELECT :A ▼ KEY
> KEY
:MENU KEY
SET
END
Push
AT
to select
“SET UP
COMMERCIAL ADV.,”
and then push ► to
display the “SET UP
COMMERCIAL ADV.”
screen.
.............. SET UP VCR ......................
REPEAT PLAY
BEEPER
SPATIALIZER
ON
ON
ON
SET-UP-COMMERCI ALr ADV.
SELECT
SET
END
A T KEY
► KEY
MENU KEY
Push
AT
to select
“MARK UNMARKED
TAPE,” and then push
► to display the screen
at right.
SET UP COMMERCIAL ADV.
C/A RECORD
C/A PLAYBACK
: ON
: AUTO
MARK UNMARKED TAPE.
SELECT
: A » KEY
SET ;► KEY
END :MENU KEY
START MARKING FROM
CURRENT TAPE POSITION.
STAFTT : PLAY KEY
CANCEL:STOP KEY
Push PLAY to start
commercial marking.
• “CA” will appear on the Multi Function Display.
NOTE:
If 15 minutes after marking is started an already marked portion
of tape is encountered, a message will appear to alert you.
Push STOP to mark the marked portion of tape.
If within 15 minutes after marking has begun, an already
marked portion of tape is encountered, a message will appear
to alert you. Push STOP to remove the message.
The selection made in step 4 remains set unless there is a power outage in which case the original factory setting
will be restored.
If the time interval between scheduled timer recordings is insufficient for marking, the VCR will wait until all
recordings are finished before marking them.
The VCR can store up to 4 programs or 40 commercial blocks in memory at one time. As marking is performed,
memory storage space is replenished.
However, if storage capacity is exceeded, the remaining commercials will not be marked.
The VCR will playback the tape at normal speed. Then, the tape is rewound and marking will be performed.
25