Panasonic PV-7664 - Manual (Page 21)

J_c^l |gg Co£2ÌngYourT^ges^(Dub^
Connections you’ll need to make. (Choose front or rear connection.)
• When connecting to a normal VCR, use the L Audio In Jack for proper sound reduction.
Playing (Source) VCR Recording (Editing) VCR TV for Monitoring
^ \ Insert a pre-recorded
I
/ tape into the Playing
(Source) VCR.
k (7
Insert a blank tape
) with record tab into the
Recording (Editing) VCR.
Select “LINE” Input mode on the
Recording (Editing) VCR. (See
“Selecting the Input Mode” at right.)
Push PLAY on the Playing VCR.
Push PAUSE at the desired starting point.
Push REC on the Recording VCR,
and then push PAUSE
immediately thereafter.
Push PAUSE on both VCRs at
the same time, to begin copying.
To Edit Out Unwanted Parts
Push PAUSE on the recording VCR while copying is in
progress. Push PAUSE again to resume copying.
Push STOP on both
VCRs to stop copying.
To Monitor Dubbing on Your TV
1
Turn your TV on and tune to the Recording
VCR channel {CH3 or CH4).
2
Set the VCR/TV Selector on the Recording
VCR to “VCR.”
Selecting the Input Mode
INPUT
Push INPUT. The display will
change in the order below.
C Channsl'"." L1NE1
Number 1
-------------------LINE2^*-^
or
Push CH A / v . The display will
change in the order below.
^ ' ► 1 — 2 —■ 3 -V
( (CATV) (TV) J
— 125 or 69-4-^ LINE2-*-LINEV
• LINE1: For rear audio/video connection.
LINE2: For front audio/video connection.
When LINE is selected, “L1" or "L2" is displayed in
the Multi Function Display for about 4 seconds.
Caution:
Unauthorized exchanging and/or copying of copyrighted
recordings may be copyright infringement.
21