Panasonic PV-7664 - Manual (Page 22)

Timer Recording
You can set up the VCR to record a one
time, daily, or weekly program while you
are away or otherwise occupied. Up to 8
programs can be stored in memory.
l^icheck list before you begin.
CH All connections are made.
(See pages 6~9.)
LJ TV and VCR are plugged in and turned on.
O VCR/TV selector is set to "VCR.”
□ Clock is set to correct time.
□ Record tab in place. (See page 5.)
@
Push PROG to display
the “SET PROGRAM”
screen.
Push AT to select
“TIMER program ;
and then push ► to
' display the program
screen.
If a program is already in memory, push AT
and ► to select an unused program number.
............ S£T PROGRAM
VCH P
1
US+ PROGRAM
SELECT: A T KEY
SET :► KEY
END ;PROG KEY
SLP
ELECT START DATE
SELECT :A T KEY
SET :► KEY
END :PROG KEY
d)
Push AT and ► to select and
set one of the following:
• 1-31 =One time recording
• DAILY =Same time MON-FRI
• WEEKLY =Same time once a week
Example
Today’s
Date
■31— 1 —2' 1^8—9‘
7 SELECTA / T Selection Order DAILY
L weekly weekly weekly J
^ (SAT) ............. (MON) (SUN)
0
)
Push AT and
to select and set
each of the remaining
items at right.
To Make Corrections, repeatedly push ► to
move the cursor to the right, or
4
to move to the
left to the incorrect entry and make the correction.
Remaining Items
to be set:
• START time
• STOP time
• CH(annel) number,
or LINE for outside
source recording
•Speed (SP, LP, SLP)
Push PROG to end
the program.
• This screen appears for
confirmation.
if you use a DSS receiver and enter a channel
number of 100-125, the screen at right appears.
^ Push AT to select
“DSS” or “CABLE,” and
then push ► to enter.
• The confirmation screen appears
above right after this selection.
To Enter More Programs
Push
AT
and ► to select and set a blank
program number, and then repeat steps 3 and 4.
voy
P DT START STOP CH SPD
2-------- —
CANCEL:ADD/DLT KEY
SELECT 1 - 8 :
a t key
ENTER :► KEY
END :PR0G KEY
IS IT CABLE OR DSS
RECEIVER?
CABLE
SELECT:A ▼ KEY
SET :► KEY
Important notes when using a
DSS receiver
• When recording programs via a DSS
receiver, the DSS receiver must be
left on.
• When recording programs via an
antenna or cable, the DSS receiver
must be turned off.
22
POWER
Push PROG to exit this
mode and return to the
normal screen.
Push POWER off
to set the timer.
* When recording programs via a
cable box, make sure the cable box
is left on. If the cable box cannot be
controlled with the VCR, you must
manually select the desired channel.
Multi Function Display
-mm-