5 usb configuration – Habey BIS-6590 User Manual

Page 40

4.2.5 USB Configuration

USB Configuration

USB Devices: 1 Drive, 1Keyboard,1 Hubs

Legacy USB Support

[Enabled]

XHCI Hand off [Enabled]

EHCI Hand off

[Disabled]

USB hardware delays and time-outs:

USB transfer time-out

[20 sec]

Device reset time-out

[20 sec]

Device power-up delay

[Auto]

Mass Storage Devices:

KingstonDataTraveler G3 PMAP [Auto]

Enables Legacy USB

support. AUTO option

disables legacy Sup-

port if no USB devic-

es are Connected.

DISABLE option will

Keep USB devices

available Only for EFI

applications.
→←: Select Screen

↑↓: Select Item

Enter: Select

+/-: Change Option

F1: General Help

F2: Previous Value

F9: Optimize Defaults

F10: Save & Exit

ESC: Exit

egacy USB

Support

To support USB device in DOS mode: such as USB Flash Disk, USB key-

board, please select or. Enables Legacy USB support.

AUTO option disables legacy support if no USB devices are Connected.

DISABLE option will Keep USB devices available only for EFI applications.

Mass Storage Devices

To select the types of the connected USB devices. [Auto], or [ floppy] or

[Forced FDD], [HDD ] or CD-ROM. System defaults as [Auto]. USB Trans-

fer time-out USB Transfer time-out can be set as 1/5/10/20 seconds. The

default time-out value is 20 seconds.

Device Reset Time-Out

To setup the USB Mass Storage Reset time-out: 10 sec, 20sec, 30sec or

40sec. The default time-out value is 20 seconds.

Device Power-up Delay

To set the number of seconds you wait for the BIOS to attempt to initialize

and recognize USB device. [Auto] or [Manual]. [Auto]: 100ms for Root to

recognize USB device. For the delay time for HUB, refer to HUB instruc-

tions. [Manual]: To set device Power-up delay in second manually. Set the

value of Device Power-up Delay to be 1sec to 40 seconds.