ITC Hemochron Response Whole Blood Coagulation System - Manual (Page 20)

20
Enabling Logging of Data
The data-logging feature is used to send raw data, obtained during an assay, to an external computer or
printer. This feature is most useful for troubleshooting.
Note: An external printer or computer must be connected and enabled before the data-logging
feature can be operated. Well 1 data are sent to COM 1 and Well 2 data are sent to COM 2.
1.
Press 7 in Set Outputs to enable data logging. YES will be displayed after the Log Data line:
7 – Log Data YES
SETTING PROGRAM OPTIONS
Program options allow the volume of audible signals and contrast, brightness, and illumination of the
display to be adjusted. Settings range from 0% (lowest level) to 100% (highest level). Press 7 or 8 to
increase or decrease the level by five percent. Press 9 or 0 to increase or decrease the level by one percent.
Pressing and holding a key for more than one second causes it to auto-repeat.
1.
Press MENU twice and press 2 to display the Program Options menu:
2.
Select the appropriate command.
Adjusting Beep Volume
The volume of the beep can be adjusted , so that it is lower (less audible) or higher (more audible).
1.
Press 1 in Program Options. The beep volume setting is displayed:
2.
Adjust the volume and press YES.
Setting Display Contrast
Display contrast can be set so characters are darker (more contrast) or lighter (less contrast).
1.
Press 2 in Program Options. The contrast setting is displayed.
2.
Set the contrast and press YES.
Setting Display Brightness
Display brightness can be set so the display background is darker or lighter.
1.
Press 3 in Program Options. The brightness setting is displayed.
2.
Set the brightness and press YES.
Note: The factory default is 50%.
Setting Flashlight Time
Flashlight Time specifies the length of time that the display is fully illuminated when a test is completed or a
key is pressed.
1.
Press 4 in Program Options. The duration of illumination is displayed.
2.
Enter the length of time (from 1 to 30 minutes) that the display should remain illuminated.
3.
Press YES.
Note: The factory default is 30 minutes. Flashlight time during battery operation is set to one
minute and cannot be changed.
Printed From ITC Intranet