Barranca Diamond CAB COMBO WORKSHOP - Manual (Page 25)

25
6. When installing the shaft assembly back in the Cab Combo Workshop, make sure the rubber
mounted bearings are centered in the bearing seat (fig 57 & 58). If the left bearing is centered in the
bearing seat and the right bearing is not properly centered, make sure the aluminum spacers are in
the correct order and that the bearings and arbor collars are properly installed.
7. Install the sanding drum with arrow of rotation facing direction of rotation (fig 59).
8. Make sure diamond wheel and drum bushings are installed.
9. Make sure the coolant splash guard is installed properly (fig 60).
Fig 51 - Outside face of diamond
wheel
Fig 52 - Inside face of diamond
wheel
Fig 53 - Bearing correctly installed Fig 54 - Bearing incorrectly installed
CAB COMBO WORKSHOP MAINTENANCE