Barranca Diamond CAB COMBO WORKSHOP - Manual (Page 11)

11
INSTALLATION OF BLADE
Remove the saw table by unscrewing the four flat-head machine screws (fig 1) that secure the table
to the reservoir tank. Remove the saw table and the cork gasket installed between the saw table and
reservoir tank.
Remove the diamond blade from its carton and mount on the 5/8" blade arbor between the two alumi-
num flanges (fig 2 & 3) with the concave sides of the flanges facing the blade (fig 4).
Fig 1 - Four flat-head machine screws
secure the saw table to the reservoir
tank
Fig 2 - Inner flange on shaft Fig 3 - Outer flange and nut installed
on shaft
A 5/8"-18" left-hand fine-thread jam nut secures the flanges and blades to the arbor shaft. When in-
stalling the blade, use an adjustable wrench to turn the nut counterclockwise to tighten the nut against
the arbor flange (fig 5). Do not over-tighten the jam nut.
Fig 4 - Concave side of flange Fig 5 - Tightening the blade on the
arbor shaft
The included 303 Pro diamond blade is manufactured to cut in a petroleum, mineral, or synthetic
water-soluble lubricant. Although water can be used with the Cab Combo Workshop, it is not recom-
mended as the steel arbor shaft and blade core can rust. In addition, poor sawing performance and
short blade life can result. If water must be used, it is recommended that a rust inhibitor be added,
such as Tool Cool (8 oz. to 1 gallon water or one tablespoon per tank).
CAB COMBO WORKSHOP SETuP