Axcess Network Receiver Installation Guide - Manual (Page 13)

© 2002, AXCESS Inc. 750.001.005 R0000 13
2. Plug the AC adapter into the jack labeled 5VDC on the back of
the Receiver (see note on page 11).
3. Plug the unit into the power outlet.
Connecting to a Computer
To connect a PC to the Receiver
1. Attach the DB9 male connector of the RS-232 cable to the RS-232 port
on the Receiver.
2. Attach the other end of the RS-232 cable to the computer
Communicating with HyperTerminal
Commands are given to the Receiver via Windows HyperTerminal
To establish communication between Windows HyperTerminal and the
Receiver
1. From the Start button on the desktop, select Programs >
Accessories > Communications > HyperTerminal .
2. Double-click the Hypertrm.exe icon to launch the application.
3. Enter any name for the connection in the Name box, select the
first icon (Figure 3), and click OK .
Figure 3 Enter a name for the connection
4. Select the com port to which the Network Receiver is connected
from the Connect Using drop-down list (Figure 4) and click
OK.