Menu – BT 500 User Manual

Page 8

Verve 500 – New Style – Edition 3 – 07.09.06 – 7706

If you experience any problems, please call the Helpline on 0870 242 6652 or email [email protected]

Talk/Standby time

In ideal conditions, fully charged

handset batteries should give about

12 hours talk time or 120 hours

standby time on a single charge. The

base must remain plugged in to the

mains and switched on at all times.
Note that a new battery pack will not

reach full capacity until it has been in

normal use for several days.

Battery low warning

If the handset has 15 minutes or less

talk-time remaining the

symbol

will flash in the display. If you are on a

call, you will hear 2 warning beeps

every 30 seconds to alert you. You

will need to recharge the handset

before you can use it again.
If the battery is completely flat, it will

take several minutes to become active

again after being placed on the

charger. You will need to charge the

batteries for 12 hours before they are

fully charged.

Battery performance

To keep your battery pack in the best

condition, leave the handset off the

base for a few hours at a time.
Running the battery right down at

least once a week will help it last as

long as possible.

Getting started

Insert the MT Li-ion 3.7V 600mAh rechargeable battery supplied
by plugging the small battery connector plug into the socket
inside the battery compartment. Make sure the battery wires are
tucked in and then slide the battery compartment cover back on.

3. Place the handset on the base to charge for at least 24 hours.

You will hear a beep and the handset display will come on
briefly to confirm the handset is sitting correctly.

4. After 24 hours, plug one end of the telephone line cord into

the socket on the back of the base and the other end into the
telephone wall socket.

Set the date and time

We recommend that you set the date and time (as shown
below) so they can be recorded with each answering machine
message you receive.

1. Press

to open the main menu. Then use the

NAVIGATION

buttons to highlight the

menu and press