beautypg.com

Panasonic 36PSU1U6 User Manual

Page 102

background image

1-96

1. Specifications

CAUTION

Do not install an air bleeder tube as this may cause

water to spray from the drain pipe outlet. (Fig. 1-76)

If it is necessary to increase the height of the drain

pipe, the section directly after the connection port

can be raised a maximum of 19-11/16".

Do not raise it any higher than 19-11/16", as this

could result in water leaks. (Fig. 1-77)

Do not install the pipe with an upward gradient from

the connection port. This will cause the drain water

to flow backward and leak when the unit is not

operating. (Fig. 1-78)

Do not apply force to the piping on the unit side

when connecting the drain pipe. The pipe should not

be allowed to hang unsupported from its connection

to the unit. Fasten the pipe to a wall, frame, or other

support as close to the unit as possible. (Fig. 1-79)

Refer to “ SUPPLEMENT ON DRAIN PIPING”.

6-25. Checking the Drainage

After wiring and drain piping are completed, use the

following procedure to check that the water will drain

smoothly. For this, prepare a bucket and wiping cloth to

catch and wipe up spilled water.

(1) Connect power to the power terminal board (L1, L2

terminal) inside the electrical component box.

(2) Remove the tube cover and through the opening,

slowly pour about 0.3 gal. of water into the drain pan

to check drainage.

(3) Short the check pin (CN5 white) on the indoor control

board and operate the drain pump. Check the water

CAUTION

Be careful since the fan will start

when you short the pin on the

indoor control board.

(4) When the check of drainage is complete, open the

check pin (CN5 white) and remount the insulator and

drain cap onto the drain inspection port.

CAUTION

To mount the tube cover, use 5/16"

(4 × 8 mm) tapping screws.

Do not use long screws as they

may puncture the drain pan and

Air bleeder

Not good

Fig. 1-76

Good

11-13/16" or less

19-11/16" or less

Fig. 1-77

No good

Upward gradient

Fig. 1-78

Good

Support pieces

Fig. 1-79

1

SM830203-01_PAC-i_US-letter.indb96 96

SM830203-01_PAC-i_US-letter.indb96 96

2012/01/19 22:39:32

2012/01/19 22:39:32