Gardner Bender Guide to Profitable Bending - Manual (Page 3)

3-point Saddle Bends with
Eegor ™ , Mini-Eegor ™ ,
Sidewinder ® and Cyclone ®
Benders
1. Determine saddle bend height (H) required.
2. Determine distance from end of pipe to the first mark. This distance
is based upon the straight length required from the connection end
to the beginning of the saddle bend. Scribe the 1st mark.
2 3 ⁄ 8 " O.D. 2" Rigid Pipe
3. Calculate the distance between the 1st and 2nd mark by multiplying
the (H) dimension by 2.
If (H) = 12”
then 2 x 12” = 24”
4. The third mark is calculated by using the multiplier of 24” (from step
3) plus twice the O.D. of the pipe, which in our example is 2 3 ⁄ 8 ” O.D.
24" + 2 x 2 3 ⁄ 8 " = 24” + 4 3 ⁄ 4 " = 28 3 ⁄ 4 " Distance
between 2nd and 3rd mark.
30 °
60 °
30 °
H
3rd
Mark Mark
Mark
2nd
1st
24˝ 28 / ˝ 3 4
1st Mark 2nd Mark 3rd Mark
54
Table of Contents
Eegor™, Ultra-Eegor™ &
Mini-Eegor™ Instructions .........................................4, 5
Eegor™ & Ultra-Eegor™
2" - 4" Offset Charts..................................................6, 7
Eegor™, Ultra-Eegor™ & Mini-Eegor™
Stub-up & Kickbend....................................................................8, 9
Eegor™ & Ultra-Eegor™ Radii Tables..................10, 11
Mini-Eegor™ Radii Tables.....................................12, 13
PVC-coated Conduit Benders.........................14, 15, 16
Eject-O-Matic ..........................................................7, 18
One-Shot & PVC 90° Stub-up .................................. 20
One-Shot & PVC Kickbends .................................22, 23
One-Shot & PVC Offset .......................................24, 25
Eject-O-Matic Sweep Benders..............................26, 27
Sweep & Segmental 90° Sweep Bends ...............28- 31
Sweep & Segmental Concentric Bends................32, 33
Thinwall Benders - Instructions.............................34, 35
Thinwall - Kick Bends ...........................................36, 37
Thinwall - Offset Bends.........................................38, 39
Milwaukee II & Sidewinder ® Instructions ..............40, 41
Milwaukee II & Sidewinder ® Stub-up .........................43
Bending Shoe Radii Tables ............................44, 45, 46
BOS57/BOSA57 No Dog Offset Bender
Instructions ...........................................................47-51
B2000 Cyclone ® Bender Instructions ..................52, 53
3-point Saddle Bends - all models .............................54
3
E-507 Guide to Profitable Bending rA.qxd 10/19/09 3:17 PM Page 5