Getting started with ao applications in software – National Instruments DAQ M Series User Manual
Page 59
Chapter 5
Analog Output
© National Instruments Corporation
5-11
Getting Started with AO Applications in Software
You can use an M Series device in the following analog output applications.
•
Single-point (on-demand) generation
•
Finite generation
•
Continuous generation
•
Waveform generation
You can perform these generations through programmed I/O, interrupt, or
DMA data transfer mechanisms. Some of the applications also use start
triggers and pause triggers.
Note For more information about programming analog output applications and triggers in
software, refer to the NI-DAQmx Help or the LabVIEW 8.x Help.