Recording setup screen, 70 menu configuration (cont.) – Panasonic AG-DVC60P User Manual
Page 70
70
Menu configuration (cont.)
The underlining indicates the factory setting.
RECORDING SETUP screen
Item/
(Display
mode)
Description of settings
TCG
(CAM) (VCR)
Use this to set the mode in which to advance
the time code.
FREE RUN:
The time code is advanced continuously
regardless of the operation mode.
It is recorded on the basis of the time
appearing on the camera-recorder’s cal-
endar clock.
REC RUN:
The time code is advanced only when
recording is underway.
It is recorded while ensuring that continu-
ity is maintained with the time code
already recorded on the tape when shoot-
ing with frame-to-frame continuity.
FIRST
REC TC
(CAM) (VCR)
Use this to select the time code to be
recorded when recording is started.
REGEN:
Select this to record the time code that will
ensure continuity with the time code
already on the tape.
The time code is recorded in the REC
RUN mode regardless of the setting
selected for the TCG item.
PRESET:
Select this to record the time code using
the value selected by the TC PRESET
item as the initial value.
However, when shooting with frame-tof-
rame continuity has taken place, the time
code is recorded to ensure continuity with
the time code already on the tape.
TC PRESET
(CAM) (VCR)
Use this to set the initial value of the time
code to be recorded.
The item takes effect when “PRESET” has
been selected as the FIRST REC TC item
setting.
1394 UB
REGEN
(VCR)
Use this to select the user’s bit to be recorded
when recording the signals of the unit con-
nected to the DV connector.
OFF:
The user’s bit selected by the UB MODE
item is recorded.
ON:
The user’s bit of the signals input to the
DV connector is recorded.
• When “ON” has been selected as this
item’s setting, it takes precedence over
the UB MODE item setting.
• If the signals do not contain the user’s bit
information, the user’s bit is not recorded.
• If no signals are input to the DV connector,
the UB MODE item setting is used for the
recording.
Item/
(Display
mode)
Description of settings
UB MODE
(CAM) (VCR)
Use this to set what is to be recorded as the
user’s bit.
USER:
The user’s information is recorded.
TIME:
The recording time is recorded.
DATE:
The recording date is recorded.
TCG:
The time code is recorded.
UB PRESET
(CAM) (VCR)
Use this to set the user’s bit.
For this, however, “USER” must have been
selected as the UB MODE item setting.
EFFECT
(CAM)
Adds effects to the images.
OFF, WIPE, MIX
ONE-SHOT
REC
(CAM)
Use the ON setting when shooting on a
frame-by-frame basis.
OFF:
Frame-by-frame shooting is not per-
formed.
ON:
The camera-recorder is set to the
frameby-frame shooting mode.
When the START/STOP button is
pressed, recording proceeds for the num-
ber of seconds selected by the REC TIME
item setting, and then the camera-
recorder is set to the REC PAUSE mode.
REC TIME
(CAM)
Use this to set the recording time for frameby-
frame shooting.
0.5s : 0.5 sec. 1s : 1.0 sec.
1.5s : 1.5 sec. 2s : 2.0 sec.