Kohler custom Bodyspa 116347-2 - Manual (Page 22)

116347Ć2Ć AA (A) Kohler Co., Kohler, WI 23
INSTALL THE KEYPAD
CAUTION: Risk of personal injury or
product damage. The metal plate must be
installed flush with the finished wall or
slightly recessed (maximum 1/4Ćinch).
Feed the cable through the hole in the metal plate.
Use two flathead screws to attach the metal plate
to the outlet box or finished wall material so the
metal plate is flush with the finished wall or
slightly recessed (maximum 1/4Ćinch).
Snap the keypad modular plug into the keypad
cable jack.
Apply silicone sealant to each of the keypad screw
holes and around the keypad edges, and secure the
keypad to the metal plate with four panhead
screws.
CAUTION: Risk of personal injury or
product damage. Prevent water damage to
the keypad by applying silicone sealant as
instructed.
IMPORTANT! Apply a continuous bead of clear
silicone sealant to the cover plate sealant
grooves, as shown.
Slip the center pin at the top of the cover plate up
through the hole in the keypad. Secure the cover
plate to the keypad with a panhead screw.
Select the bottom cap - it contains a small pinhole,
and has a small notched area along the contact
surface edge.
IMPORTANT! Apply clear silicone sealant to
the back surface of the bottom cap, and also to
the edge that contacts the cover plate. Align
the bottom cap holes with the cover plate pins,
and push the cap into place. Repeat for the top
cap.
Remove any excess sealant.
Check Point #9
- Faucet trim and spout installed.
- Drain assembly installed.
- Footbath basin filled with water and checked for leakage.
- Door enclosure installed.
- Tower installed.
- Keypad installed and sealed with silicone sealant.
- Keypad wiring connections made.
INST
ALLA
TION