Kohler custom Bodyspa 116347-2 - Manual (Page 2)

116347Ć2Ć AA (A) Kohler Co., Kohler, WI 3
THE TOWER AND SYSTEM
Your Kohler Custom BodySpa is designed to
stimulate, invigorate, and energize your body for
total hydroĆmassage relaxation. The Custom
BodySpa tower features 10 BodySpa jets in five
paired arrays, and a lighted, overhead Waterfall to
personalize your BodySpa experience. With the
BodySpa tower, you have complete freedom of
movement (and choice) to focus your
hydroĆmassage where you need it the most.
The Custom BodySpa system features an
easyĆtoĆread electronic keypad control. With the
keypad, you can individualize each BodySpa
adventure by selecting the lighted, overhead
Waterfall or any combination of five pairs of
BodySpa jets. You can vary the intensity of your
BodySpa hydroĆmassage from gentle to vigorous
with the touch of a finger.
The quiet but powerful 2Ćhorsepower pump and
motor propel and recirculate the hydroĆmassaging
water up to two times each minute. An integral
heater helps maintain the temperature of the
water as long as the Custom BodySpa is running.
PROVIDE SUFFICIENT ACCESS
You must provide sufficient access to the pump box
and controls, drain connections, suction housing,
water supplies, and any lighting fixtures or other
accessories. The false wall discussed on Page 4 may
provide adequate access to all necessary
components.
ROOM SIZE
We recommend a room size approximately 60Ćinches
long x 48Ćinches wide x 84Ćinches high for the
Custom BodySpa installation. The basin design
must provide for a water depth of at least 9Ćinches
measured along the basin wall. Construct the basin
framing to result in an overall basin water capacity
between 90 and 200 U.S. gallons (study the chart at
left). A room size of at least 47 x 50Ćinches will be
large enough to promote freedom of movement
while using the Custom BodySpa, yet small enough
to contain the comforting heat and moisture
produced by the system.
A smallerĆsized room may not support the required
WaterĆFree Zone" area for the user to move clear of
the powerful water stream.
If you design the room much larger than 60 x
48Ćinches, you need to consider adding an auxiliary
heat source to compliment the integral pump heater.
This auxiliary heat source could be a steam
generator. Any auxiliary heat must have its own
separate electrical service.
DESIGN
GUIDE