IBM Switch 9077 User Manual
Page 65

Router Node
47
2.4.2.3 The endefadapter Command
The
endefadapter
command is used to add or change the extension node
adapter IP information in the SDR DependentAdapter object, and can be
executed using
smit
. The fast path for
smit
is
enter_extadapter
. The command
options are shown in Table 9.
Table 9. endefadapter Command Options
2.4.2.4 The enrmadapter Command
The
enrmadapter
command is used to remove the SDR DependentAdapter
object, and can also be executed using smit. The fast path for smit is
delete_extadapter
.
Flags
SMIT Option
Description
-a
Network
address
Specifies the IP address of the extension node.
-m
Network
netmask
Specifies the netmask for the extension node.
-r
Reconfigure
the extension
node
Specifies if the
enadmin
command is to be
activated after the
endefadapter
command
completes. With this option, the user does not
have to explicitly issue the
enadmin
command. If
the specification is
yes
, the
-r
option is part of the
command. If the specification is
no
, the
-r
option
is not part of the command.
Node number
This is the node number the extension node
logically occupies in the RS/6000 SP.
Note that this command only affects the SDR, unless the
-r
option is
issued. The
-r
option should be issued only if the
endefnode
has been
executed for the extension node.
When the GRF is properly configured and powered on, with the SP Switch
Router Adapter inside, it periodically polls the Control Workstation for
configuration data. The
-r
option or
enadmin
command is not required to
activate the polling here.
Attention