Iomega DataSafe Network Device User Manual

Page 36

DataSafe NAS User’s Manual

Figure 8

DNS Configuration

5. Next to the

Configuration

option, select the

Obtain configuration from DHCP server

radio button.

6. Click

To manually set the DNS servers to be used by

the DataSafe NAS

1. On the primary menu bar, click

Network Setup

2. On the Network Setup page, click

Interfaces

3. From the

Object Selection

table, select the

network connection to modify.

4. On the

Tasks

list, select

DNS

5. Next to the

Configuration

option (see Figure 8

on page 31), select the

Configure manually

radio button.

6. Enter the appropriate server name in the box next

to the

Add

button, then click

Add

7. To add another DNS server, repeat step 5.
8. When you are finished adding DNS servers, click

Note:

If the IP address is set to be obtained from
DHCP, and you set DNS manually, the system
will accept the manual input, and the
properties on the DataSafe NAS will
automatically be set to

Configure

manually

. However the

Current

Configuration

column of the

Object

Selection

table on the

Network Adapters

page will still show DHCP as the source of the
IP address. You can go back into the

DNS

settings

properties page to confirm that the

manual configuration has been saved.