Minicom Advanced Systems Minicom Smart 216 - Manual (Page 34)

SMART 216 / 232 IP
33
Figure 31 Manual Video Adjustments controls
Brightness / Contrast - use the scales to adjust the brightness and contrast of the
displayed image. Move the sliders to change the displayed image. Click in the area
of the sliders for fine-tuning.
For the following controls choose the appropriate measurement.
H. Offset - defines the starting position of each line on the displayed image.
V. Offset - defines the vertical starting position of the displayed image.
Phase - defines the point at which each pixel is sampled.
Scale – defines the scale resolution of the session image.
Adjust Phase and Scale to reduce noise level to a minimum.
Select Filter - defines the filter of the input video from the server. A higher filter
reduces the noise level but makes the image heavier.
Noise - represents the Video "noise" when a static screen is displayed.
26.6 Power cycle
Where a Serial Remote Power Switch is connected to the Serial port of the
Smart 216 / 232 IP, you can power manage the Target servers as follows:
From the Toolbar, click . The Power menu appears, see below.
Figure 32 Power menu