5 adjusting the video settings, 1 refresh, 2 video adjust – Minicom Advanced Systems Minicom Smart 216 User Manual
Page 33: 3 advanced

USER GUIDE
32
26.5 Adjusting the Video settings
To change the video settings:
From the Toolbar, click
. You have the following options:
· Refresh
· Video Adjust
· Advanced
Each option is explained below.
26.5.1 Refresh
Select Refresh to refresh the Video image. Refresh may be needed when changing
the display attributes of a Target Server.
26.5.2 Video Adjust
To adjust the video automatically:
Click Video Adjust. The process takes a few seconds. If the process runs for more
than 3 times, there is an abnormal noise level. Check the video cable and verify that
no dynamic video application is running on the Target Server’s desktop.
Perform the procedure where necessary for each Target Server or new screen
resolution.
26.5.3 Advanced
Use the Advanced video adjustment options for fine-tuning the Target Server video
settings after auto adjustment or for adapting to a noisy environment or a non-
standard VGA signal or when in full-screen DOS/CLI mode.
To adjust the video:
Click Advanced. The manual controls appear, see Figure 31.
After adjusting the video manually, you can always revert to Auto settings by
clicking Auto Video Adjust – explained in section
26.5.2 below.