Welch Allyn Lithium Ion InstructionManual - Installation Guide Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for Lithium Ion InstructionManual - Installation Guide Welch Allyn
Manuals 
| Recognized languages: | English Español Français |
|---|---|
| Pages: | 2 |
| Size: | 204 KB |
Show table of contents
Document Outline
- 719 Series Lithium Ion Handle
- INTRODUCTION
- SAFETY AND WARNINGS
- Avant d’installer le block-batterie, veuillez lire les informations suivantes et les conserver pour consultation ultérieure.
- Parts List
- OPERATING INSTRUCTIONS
- 1. Connect instrument head to the handle.
- 2. Depress On/Off Button on Rheostat Section and rotate the Light Intensity Control Ring clockwise (CW). To intensify light, continue to rotate until stop is reached (Figure 1).
- 3. To turn off, rotate counter clockwise (CCW). Button will click when fully off. Turn fully off after each use to ensure maximum on-time from the battery.
- CHARGING INSTRUCTIONS
- 1. Remove instrument head.
- 2. Insert T-stud on the AC Charging Module into the T-slot on the Battery Section (Figure 2). Rotate 90˚ in either direction. T-stud will lock into place.
- 3. To expose prongs, depress lock Button on the AC Charging Module (Figure 1). With the Lock Button depressed, slide Sleeve toward Rheostat Section.
- 4. Plug into standard (110-120v 50/60 Hz) wall outlet. Charge for 18 continuous hours to charge a dead battery.
- 5. Battery may be charged after partial discharge without negatively affecting overall battery memory (unlike Ni-Cad cells).
- 6. Do not attempt to use the instrument during charge, the instrument will not operate. When charging is complete remove the han...
- 7. Slide sleeve back over prongs. The Lock Button will click when prongs are fully hidden.
- 8. Remove AC Charging Module from the Battery Section if desired.
- LOW BATTERY INDICATOR
- BATTERY REPLACEMENT
- Removing the old Battery Secton:
- 1. Hold the instrument handle firmly by the Battery Section.
- 2. Place the Battery Removal Tool around the Chrome Ring, below the Rheostat Section (Figure 3).
- 3. Squeeze the arms of the Battery Removal Tool together, to obtain a grip around the Chrome Ring.
- 4. While squeezing the arms of the tool together, start to turn the tool in a CW direction (when viewed from the top). This will unthread the Battery Section from the Rheostat Section. NOTE: only the Chrome Ring turns.
- Replacing a New Battery Section
- Removing the old Battery Secton:
- CLEANING
- SPECIFICATIONS
- SERVICE AND WARRANTY