RIDGID AC1030 Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for AC1030 RIDGID
Manuals 
| Recognized languages: | English |
|---|---|
| Pages: | 6 |
| Size: | 524 KB |
Show table of contents
Document Outline
- General Safety Instructions for Power Tools
- 1. Unplug the saw.
- 2. Remove the blade guard, the saw blade insert, and the saw blade.
- 3. To remove insert:
- a. Make sure saw is off and unplugged.
- b. Loosen flathead screw.
- c. Lift insert from front end, and pull
- 1. Insert should be flush with table top. Check as shown. Loosen flathead screw that holds insert and adjust the four set screws as necessary. Tighten flathead screw. Do not tighten screw to the point where it bends the insert.
- 2. Remove the dado/molding insert and install the dado or molding head... replace the insert.
- Using the Dado and Molding Insert
- 1. Before using the dado or the molding head...or the insert, read and understand the Safety and Operating instructions contained in the Operator’s Manual furnished with your table saw and the instructions furnished with your dado head or molding head.
- 2. The dado or molding head can be used with the saw arbor tilted BUT NOT IN ALL POSITIONS... NEVER TILT THE ARBOR WHILE THE SAW IS RUNNING.
- 3. Rotate the dado or molding head manually, (don’t touch it with your fingers, but use a stick of wood) to be sure it clears the insert before connecting the power cord to the electrical outlet in your shop.
- 4. Never operate the saw without the proper insert installed.
- 5. When replacing the saw blade and saw blade insert, always replace the blade guard.
- DADO/MOLDING
- HEAD INSERT
- 3-8-06 (REV:00)